Mounting and Installing the Parking Dynamics PD1Parking Dynamics PD1 is a wonderful car parking sensor that will fit any make of car or vehicle including van, caravan, trailer and horse boxes. So it’s a parking sensor for any vehicle. The best thing about Parking Dynamics PD1 car parking sensor is that it can be mounted and installed without spoiling the original shape of bumpers. The fantastic parking sensor comes in two versions;Parking Dynamics PD1 (plastic) andParking Dynamics PD1 (metallic). The device works superbly with plastic bumpers, but doesn’t have any problems at all with metallic bumpers. As 97% of cars have plastic bumpers, theParking Dynamics PD1 (plastic) is preferred more. Parking Dynamics PD1 sensor parking system is installed inside of your car where the reversing light is situated. Its antenna wire is passed thru the hole with the grommet fitted to connect to the antenna; this hole is now provided by vehicle manufacturers for their own parking sensors. In case there’s no small hole there, it’s drilled and the wire is passed thru using a grommet. The antenna wire is connected with the sensor antenna. The sensor antenna that is the car parking sensors silver self adhesive strip is stuck onto the inside of the rear bumper. Before attaching the sensor antenna to bumper, it must be made sure that its surface is clean. While
installing the Parking Dynamics PD1 car parking sensor, the bumper of your
car may need to be removed, however there are many cars that lets
the job done by just loosening the bumper. Most of auto electricians,
mechanics and body shop technicians can help remove the bumper and
install the Parking Dynamics PD1 car parking sensor. Parking Dynamics PD1 electrical connections are very important to be kept in mind while mounting/installing the parking sensor. The red wire should be connected to the supply wire of the reversing light. The black wire must be connected to the ground (body/chassis) of the vehicle. The car parking sensor speaker should be fitted on the rear parcel shelf or in a convenient position for the driver. It is important that the antenna is installed at the highest part from the ground that corresponds to the furthest distance from the vehicle body. Generally the best position of the sensor antenna is 50cm from ground level. However if this not practical the unit should be fitted as close to 50cm as possible. If
your car parking sensor is over sensitive, you can de-sensitized
it by adjusting the screw in the top left hand corner of the car
parking sensor unit by one turn at a time, clockwise. And, if your
sensor is under sensitive, you can sensitize it by adjusting the
screw just one turn at a time, anti-clockwise. But in 99% of cases,
Parking Dynamics PD1 offers 100% perfect detection sensitivity.
|
